Everyone seems to be into DIY these days. DIY, as you probably well know, means Do-It-Yourself and it can be about almost anything. Although it’s usually most used to describe something that’s done within the home. Like fixing your own roof, flooring, or your own bathtub, for example.

Arlington TX Bathtub

Now bathtub refinishing isn’t easy. It’s quite complicated especially for beginners, but then most DIY projects are like that. Anyone who wants to DIY their bathtub refinishing project better be ready for the challenges that it will have. If you want to do it, then you could use some guidance to pull it off.

So here are the steps from Bathtub Refinishing Arlington TX that would ultimately show you how to refinish your bathtub – the DIY way:

Step #1 – Clean the Bathtub

The first step is to make sure that your bathtub is clean. In many ways, this is the most important step since none of the things that you’ll do afterward will matter much if you don’t clean it properly at the start.

To start, remove all of the hardware from the bathtub. Do not forget to include the caulk in the things that you’re going to remove. In order to clean your bathtub as thoroughly as possible, use a decreaser.

Step #2 – Start Repairing the Chips

You’ll need to start repairing the chips in your tub. Since your tub has been in use for years, it’s bound to have chips on it and it could have a lot. 

For the repair, you’ll need to mix a two-part epoxy filler. Mix it until the epoxy is able to form a paste-like consistency. 

Use a putty knife to apply the epoxy in order to fill any chips that your bathtub might have. To remove any excess epoxy, use the putty knife to scrape it away. This will help reduce the sanding time later on.

Step #3 – Take Care of Rough Spots

After the epoxy has hardened, you can start smoothing out any rough spots that you see in the bathtub. Use a utility knife for the purpose. And if you don’t have that, you can also use sandpaper or orbital sander.

Step #4 – Scrub the Bathtub

Time for you to scrub the bathtub. For that purpose, you will need to use either sandpaper or steel wool. Scrub the bathtub three times and in between the scrubbings, vacuum the surface as well.

Step #5 – Cover Some of the Areas

Cover the areas that need to be specifically protected in the bathtub. There are several ways to cover those areas. You could use paper, tape, or a drop cloth for the purpose.

Step #6 – Start Applying the Paint

To get the best results for your bathtub refinishing projects, you will need to apply paint to your bathtub. Use an air compressor to spray paint the bathtub with the color of your choice. If you are not able to spray paint your tub, then using a paintbrush is also an effective way to do it. Apply a second coat after letting the first coat dry for 15 to 20 minutes.

This simple guide on how to refinish your bathtub the DIY way will allow you to do the process correctly and get the results you want.